LED bar for Fossils Stuff Gravity FSGX210 and side cover

thingiverse

LED bracket for Fossils Stuff Gravity FSGX210 frame clips to rear. Accepts three addressable LEDs via LED strip. Superglue the LED bar to the clip/bracket first, then fit the clip to the frame, check it, and glue the LED bar on afterwards. Press parts together firmly for a good while before flying/crashing! Side blanking panel clips into the USB access hole. It's easier to loosen the frame bolts first, so the two frame parts separate slightly, slide the panel in place, then retighten the frame bolts. Print Settings: Printer: Wanhao Duplicator i3 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 100% Notes: ABS plastic Layer Height: 0.2mm Speed: 240 / 95 mm/s No raft, supports on, 100% infill Perimeter thickness: 0.8mm Top and bottom thickness: 0.8mm Cooling off with enclosure and glass bed on thermal pads + 3D-Lac spray adhesion