LED Bar for Ender 3 V2 on X-Axis

cults3d

The first modification I made on my Ender 3 V2 was to add led lighting on the top, but this produced shadows with the X-axis and fuser block on the parts. I improved that same design I did the first time so that it could be inserted on the opposite side of the fuser shaft without disturbing any printer parts. This design is based on fastening the profile from 3 different points inserted to the X-axis itself, with an inclination angle of 22.5 degrees towards the fuser. A 10mm led strip, 15 to 17 centimeters long, is required, to be inserted laterally once the profile has been inserted into the axis. I have used a WS2812B strip, with 10 leds in total. To this I have added an SP110E driver which is powered by a 5V USB port. Plus 1 meter of 3-pin JST cable so that the installation does not interfere with moving the X-axis along the Z-axis. The model itself carries a diffuser in case we do not want to leave the leds unprotected. I also add an additional fastening in case you want to use it to reinforce the security of the cable to the strip.