Lectric EBike Display Cover

cults3d

This is a cover for the Lectric Ebike's display. It is not waterproof. I did use supports for the slot on the top and the lip on the bottom. I printed it face down. It attaches by putting the bottom lip behind the bottom of the display and tilting up. Then the small panel slides into the slots which holds the case in place. It's a tight fit. Updated V2 to make the cover a bit thicker and sturdier as the original can split at the insertion point if it gets jarred. The update uses the original back. Print it face down with Tree Supports. The slot it tough to get the supports out but it's strong enough that you can use an exacto knife to get it out.