Leatherman Flat Bit and Ratchet Driver Pocket Container

thingiverse

I saw similar designs on here, and noticed the ratched driver gets no love. So I created a pocketable container that can hold it. It should also work with the regular bit extension. The part of the tool that is friction fitted into place, so it should fit fine. It's VERY tight to start, but wears down to something much more reasonable with just a few insertions and removals. You could also file down the protruding lines that rub against the tool or the bit kit to accelerate the wear process. No supports are needed if it's printed in PLA or PETG if the orientation the STL uses. I did a 40% infill and 0.2mm layers. So far it's survived being dropped on concrete from chest height. Version 2.1 gives a slightly looser fitment, and wider holes for gripping the bit driver, so if the original 2.0 version was too difficult to use, this should be better.