League of Legends: Arcane - Jinx Goggles

cults3d

This model is NOT for beginner. I had a hard time to doing it right. Come out with several design and this should be the least difficult design to print. Some crafting skill is needed as well as there will be a lot of post processing which I hate the most. I separate the goggles into 6 parts, Side, Bottom, Lens, Lens frame, Bridge and Middle. You can refer to the picture in the preview with label for each part. Bottom part is optional to print as you can use other material such as Eva foam to craft. Side part is optional if you can find some metal rod as substitute. If you want to print, please use at least 20% infill as you will need to drill a hole on the parts to connect a metal rod to the Middle frame. I did design a small pad for you to drill holes on both Side and Middle pieces. If you want to connect direct to the pole, you can just remove the padding with clippers and sand down the residue. Other than Side pieces, other pieces can be combine by some superglue. The goggles is 11cm in total. You can scale individual part following your needs. Please note that Bottom, Middle, Lens frame and Lens pieces need to be scale in the same factor for both width and length. Will not suggest to scale the height as the design in the show is quite thin tho. For the bridge, it is connect to the Middle piece. Some sanding near the connection part is needed to make the pieces connect together. Last but not least, please think twice before you decide to print this design. It is quite small and there will be a lot of support needed too. I do include a full piece .stl file for you too if you plan to do and slicing or cutting yourself. Cheers and thanks for reading all these nagging! Happy printing! ;)