LD 002H Lid Knob / Handle

thingiverse

Creality LD 002H Lid Knob / Handle After a few prints I noticed how hard / annoying it was to pick up the lid with both hands. this was an interesting task as most of the time I had a bed with a fresh resin print attached in one hand, or I had to leave my vat open to the light while I put the part and bed in my cleaner. also I was getting finger prints and resin stains on the lid. the answer was simple, print and fix a handle or knob to allow single handed use. I printed mine with no supports and it came out pretty well but some printers may require some support to make it print successfully. the model had an M6 thread with 15mm depth. infill I did at 30% and at 0.2mm layer heights. you will need to drill a 6mm hole in the centre of your lid to fix this knob and I would recommend using a washer on the inside of the lid to give good purchase and spread the load.