LCR T4 Tester (123 1111) Easy Print Housing

thingiverse

Hi there! I've finally got my hands on the tester ESR T4 from Aliexpress, and I'm excited to share my experience with you. I started looking for a suitable box for this tiny circuit, but I was disappointed by the options available. Most of the boxes I printed were either tricky to print or lacked ergonomics. So, I decided to take matters into my own hands and design a custom box that would perfectly fit this little circuit. After 12 hours of labor and four test prints, I'm thrilled with the result! The best part? No supports needed - it prints like a charm in PLA. Plus, there's a clever cable management system under the battery location (check out the picture). I hope you'll find this design as easy to print and practical to use as I do. To get started, you'll need: 1. LCR T4 tester (pin configuration 123 1111) - be aware that there are several models, so make sure to check my pictures for reference. 2. A specific model can be found here: http://s.click.aliexpress.com/e/nG7T8AU 3. Countersunk head screw M3 x 5 for the battery box: http://s.click.aliexpress.com/e/c84ZTCbO 4. Two M3 x 10 normal head screws and three simple M3 nuts: http://s.click.aliexpress.com/e/crbqSwSM 5. Four self-tapered screw M1.7x 3 or x5 to hold the pcb: http://s.click.aliexpress.com/e/TONrIxI 6. Three banana socket 4mm (drilling diameter 12mm - max length 31.5mm): http://s.click.aliexpress.com/e/c8w590za Happy printing!