LCR-T3 Case - Remix

cults3d

I found this posted here - https://www.thingiverse.com/thing:2066610 - but I'm positive that this design is actually the same one posted here - https://www.thingiverse.com/thing:896665 - two years ago. In any case, I discovered several issues. First, the lip around the bottom was too weak - it detached easily from the rest of the case with minimal force. This was addressed by thickening it and increasing the angle of the overhang to add extra support. Secondly, the battery "clip" exhibited the same weakness. This was also thickened to provide additional support. Thirdly, the top right-hand screw hole was enlarged and attached to the case just like the other two for added stability. Lastly, with the battery endstop in its current position, the battery couldn't fit into the holder properly due to a hard plastic connector that wouldn't bend like the thin connector used on most 9v battery equipment. This was rectified by moving it 4mm. This ensures a snug fit without having to break that tab. For those who don't have issues with the original(s), this revised design offers no reason to change. For those who do experience problems, perhaps this updated version may provide the solution they need.