LCD Ribbon Cable Clips for Prusa MK4

prusaprinters

This is a remix of @Real3DPrints original model.   After printing the original model, I found the clip to be not wide enough to accomodate the MK4's ribbon.  I re-worked the model a little and made the four ‘fingers’ longer.  As you can see in the photos, the ribbon fits with a little more room to spare.I also found the ribbon was a little hard to thread between the hooks at the end of the clips.  So that has been widened a little.Finally, I used hammer head t-nuts https://www.amazon.com/gp/product/B08ZNG75VW/ref=ppx_yo_dt_b_asin_title_o05_s02?ie=UTF8&th=1 to hold the clips in place.If you notice, I did not remove the original vertical clips on the printer.  I left them in place because the hassle of removing them - instead they hold the yellow cable going to the LCD.  These clips were printed on a MK4 in PLA.