LCD mount for Prusa i3

thingiverse

I was looking for a mount that would perfectly fit this case: https://www.thingiverse.com/thing:213852. The ideal design should bolt straight onto the back of the top Z-axis mount using longer M3 bolts, and sit far enough back to avoid any interference with the extruder. I created the design on Tinkercad, but in hindsight, I probably should have mounted the case a bit to the left to prevent potential issues. If I hadn't done that, my extruder motor might hit the knob if it reaches that height someday. Note: When cutting off the edge at the bottom, I made sure to rotate the nut holes so there wouldn't be any bridging that could sag during printing. To fix the problem with the deep holes, I had to smooth out the sags using a warmed-up screwdriver before the nuts would drop in place.