LCD 2004 Display Holder (e.g. Anet A8)
thingiverse
I printed the enclosure in PETG. To improve print quality, I added a 0.3mm surface on the bottom of each screw hole and then removed it again before uploading. The enclosure was screwed to an Ikea LACK table using five M3 18mm screws. Two M3 8mm screws secured the display firmly in place. Although I didn't use all available screw holes, only those closer to the edge of the table were used. Future plans involve designing a protective cover for the display screen. When buttons are pressed, the enclosure shifts slightly downward, but this issue can be resolved by placing one or two screws on either side of the table. This potential solution has not been tested, and I'm satisfied with the current setup.
With this file you will be able to print LCD 2004 Display Holder (e.g. Anet A8) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on LCD 2004 Display Holder (e.g. Anet A8).