Lazy Bastard Achievement Clock

thingiverse

I had been putting off releasing this because... lazy It should print fairly easy though it is a large print (200mm) if you change the scale it messes with the holes so if you were wanting it as a clock then you'd need to make modifications (easy to do in blender) If getting a clock mechanism I designed it around a 20mm long shaft clock that is 56mm square. Center hole is 7mm diameter offset 5mm upwards from center. Center ring is 165mm for making a paper clock face. (no glue necessary) Uses M3 screws to attach the halves together note: the long inserter hand sort of clips the leg so it may need to be bent upwards slightly I would recommend printing the top half (the engineer) with no bottom layers to save a lot of print time since it faces the wall.