Lawnmower cable clip

prusaprinters

<p>Clip to hold the cables on a Craftsmen lawnmower handle. Lawnmower did not have anything holding the cables, so someone zip tied the cables tight to the handle. When the handle was folded up, the cables were over stretched and snapped. After replacing the cables, I made this to hold the cables in place but still allow them to move when the handle is folded.</p> <h3> Instructions</h3> <p>Should print on just about any printer. I had good luck with 3mm filament and 40% infill. Flexed enough to snap on tight without too much force. Stiff enough to stay in place.</p> Category: 3D Printing