Lathe Chuck Key Holder and Quick Change Tool Post Holder
thingiverse
There were a few AXA quick change tool holders out there but no AX0 that I could find. I tried these in a few infill options. For the tool holders, it didn't make much difference from 15% to 100%. For the chuck holder, I ended up doing 100% because they key was much heavier than the tool holders. I may reprint in ABS, but it seems it will hold up fine at 100% infill. I didn't use support on any of these, but the chuck key holder came out a little shady a couple of times (you can see in the pics) so it may be cleaner to print that one with support. This is for the 8 x 16 budget lathe. Both of these have 2 each 12mm x 12mm x 2mm holes to attach the magnets at the link below. They are not needed but they do help hold the tool against the splash guard. Chuck holder is: 40mm wide x 40mm deep x 40mm tall 22 mm hole 12 mm cross bar AX0 holder: 40mm wide x 28.5mm deep (without the tool attached) x 40mm tall with a 14mm gap to fit over the splash guard Magnets: https://www.aliexpress.com/item/32837865493.html?spm=a2g0s.9042311.0.0.27424c4daHOvzV
With this file you will be able to print Lathe Chuck Key Holder and Quick Change Tool Post Holder with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Lathe Chuck Key Holder and Quick Change Tool Post Holder.