Lathe Chisel Angles

thingiverse

I recently required some angles for my lathe chisels, so I swiftly designed them using Fusion360. The angles are marked as negative on the parallel end. I printed these pieces on my Ender 3 with a high infill setting of 50% and four layers per plate, which took approximately two hours to complete at a draft quality of 0.2. Each piece is 6mm in height, with the text being an additional 2mm higher, making the total height 8mm. To achieve this, I adjusted the scale in Cura so that only the Z-axis dimension was changed to 6mm, while keeping all other scaling factors intact. Edit: The images provided show the bottom side of the pieces, with the numbers located on the opposite side. I apologize for any confusion, as this is a new experience for me.