Lateral spool holder for FF Creator Pro 2016

thingiverse

This is a spool holder designed for use with the FF Creator Pro version 2016 printer, and possibly other models. It attaches to the side of the printer via two screws that secure the lateral panel. The wheelbase measures 150mm. The screws used should be approximately 15mm in length, and the pin is a threaded bar measuring M10. An initial design was created, but it showed some flexibility, prompting the addition of extra reinforcement via a second file. Further improvements are planned to accommodate longer filament tubes, with a tube holder on its way. Print Settings: Printer: FF Creator Pro Rafts: No Supports: No Resolution: 0.2mm Infill: 25% Notes: Approximately 3 hours are required for printing.