Laser Quickmount

thingiverse

Since the original laser mount didn't work with mine, I made this one myself. This is a pretty fast sketch and I wanted something where I didn't need supports to print it, which is why it's offset so much. On a side note, this is a 3-port laser (12v, PWM, GND) but the PWM signal can only take up to 5 volts. If you need a 5-volt signal, check the pins where the BLtouch usually goes (D11). On my CR-10S I have an extra pin left (D12) which is 5 volts and where I get my signal. The actual quick-change mount comes from ProperPrinting (https://www.thingiverse.com/thing:3369444) and is for the CR-10 and Ender 3 series, but you can find other mounts for other printers under remixes. Please be aware that I am using a D-SUB 9 socket contrary to ProperPrinting who uses a D-SUB 15 type one.