Large Tormek T3 tub

thingiverse

This is a larger tub than standard for the Tormek T3 wet grinder. It's designed to accommodate an SG-250 stone after it has worn out and is too small for the T8. This way, you can get more use from a discarded stone given by friends who have the T8. It has space for magnets in one pocket. These will help clear metal shavings (and water) off the stone. A test piece is included to check if your printer's dimensions are accurate enough. Use it to save time and filament, just in case you need to adjust the dimensions slightly. I printed this tub in PLA and it holds water perfectly fine. As seen from the picture, it's been used a lot already (about 15 months of weekly use). It may fit on the T4, I'm not sure (but please leave a comment if you test it).