Large D20 Holder

thingiverse

I designed a custom holder for my new D20, which I acquired at a Renaissance Festival. The illumination system consists of a tri-color LED connected to an Arduino board, a bit more complex than necessary. There is just enough space on the holder for a small breadboard and the Arduino itself. Print Settings: Printer: Anet A8 Rafts: No rafts were used. Supports: Yes, only top case support was required, as supports are not needed for the arms that hold the die. Infill Density: 15% Resolution: 0.2 mm Notes: The holder is designed with a minimalist approach, and support material is only needed for the top case inside. The arms holding the D20 do not require any support material.