Large Bin System for Original Enclosure & MK4

prusaprinters

A set of four bin boxes compatible with a MK4 Printer in an Original Enclosure.FeaturesBoxes reside on the Enclosure's bottom panel with no connection to the printer frame, reducing vibrations.Boxes align with the anti-slip dampers and holes in the Enclosure bottom panel.Tongue and groove connection between the boxes keeping them snugly in place.Partially raised bottom at the front for xLCD display cables.Partially raised bottom at the front left corner for LED/Add-On cables.Update 17.01.2024: Left box available in two versions.with_xLCD_CableChannel: For default installation with xLCD running diagonally from the left z motor towards the MK4 frame (new, see comments for pictures).without_xLCD_CableChannel: For installations with modified xLCD QuickRelease where display cable runs inside the MK4 frame. (Unchanged compared to first upload, but renamed).45° angle at front boxes, maximizing space while leaving enough room for additional cables at the inner side of the front bottom Enclosure profile.Additional NotesAll boxes have holes on the bottom, aligning with the holes in the Enclosure's bottom panel. These holes have a depth of 2.2 mm, which might not be enough if you used longer screws in any of the panel's holes covered by the boxes.PrintingPLA with MK4 and default settings with Input Shaping and “0.2 mm SPEED”.Support on build plate, only for the raised bottom sections required. Fairly easy to peel off with a sharp knife.No support for 45° front walls or the cylindrical cutouts for the anti-slip dampers required.Attention: Using PLA on Satin Steel Sheet resulted in delamination of the large side boxes.Using the flat Steel Sheet worked. You may still want to consider adding a Brim. PS: This is my first upload on Printables. I am looking forward to your feedback.