Large Bender Piggy Bank for Creality CR-10 and other large printers

thingiverse

I redesigned this bust into a bank as part of my YouTube review of the Creality CR-10 (https://youtu.be/FPgnjmNCEak). I was inspired by Joel Telling, the 3D Printing Nerd, who printed an upsized version of the bust and cut a hole in it to make it a bank. Instead of doing that, I wanted to incorporate the coin slot and plug in the bottom. It has been scaled up to fit the CR-10 or similarly large printers (at least 400mm vertical build volume). It does not require any support material, but I think it should be printed with at least 10% infill and enough top and bottom layers to ensure that the top of his head comes together without any holes. The other settings are up to you, but I probably wouldn't go too low on the layer height or it will take forever to print. The cap/plug on the bottom might be a little tight depending on your printer's tolerances.