Laptop Vesa Mount

thingiverse

After printing the parts from Biolook, I worried that the screws were too close to the edge of each component. So, I decided to remix them, moving the screws further inside the part. I removed the cable holders since they aren't necessary; our workspace is cluttered enough without them sticking out. The other dimensions are relatively unchanged. We used a 1mm nozzle to print it quickly, but this resulted in a less-than-fine or pretty finish, though functionality remains intact. Additionally, we encountered an issue with the filament running low without any detection on our Ender 3 printer. When we finally replaced the filament, small gaps appeared throughout. I used a 3D pen to repair the part and fill these gaps (also adding some color to the letters in the process). This is why there are so many colors visible in the photo.