Laptop Stand - Macbook Pro (Early 2011 - 13 inch)

prusaprinters

<p>Simple angled laptop stand for my Macbook Pro. Wanted a sharper angle to take up less deskroom. Will likely support other laptops -- the gap between vertical supports is 17mm.</p> <p>Inspired by <a href="https://www.thingiverse.com/thing:2597930">this design</a> but rebuilt in Tinkercad. I wanted to round out the leading edges and provide additional support to the rear support. Slimmed and widened the base.</p> <h3>Print instructions</h3><h3>Category: Computer Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> <a href="http://amzn.to/2rqZ6Uo">i3 MK3</a></p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> .3</p> <p><strong>Infill:</strong> 10%</p> <p><strong>Notes:</strong></p> <p>Used printer settings inspired by this Makers Muse <a href="https://www.youtube.com/watch?v=3kW9SnK4LKc">https://www.youtube.com/watch?v=3kW9SnK4LKc</a> video.</p> <p>In case it's not obvious, you'll need to print two of these :) Each took about 1.5hr using 'Stupid Fast' settings.</p>