Laowa 24mm diversion mirror attachement

thingiverse

This is a 90° diversion attachment for the Laowa 24mm Probe lens. It´s designed to glue a mirror to the 45° angeled area. Althoug it works with a normal mirror (max thickness of the mirror 4mm) consider getting a front surface mirror to prevent unwanted (double) reflection. Any Mirror with a thickness between 1mm and 4mm will work. Attach the mirror while camera is on to check your mirror alligns. I tested it on a Red Epic Helium 8k and Canon R5 4k HQ and it works fine, however if you want 36x24FF you might encounter a little bit of reflection of the housing in your shot depending on the mirror thickness. Mirror Size shouls be 65mm x 58mm To clamp it on the lens it uses a M4x34 Allen Screw, the Hex nut was pressed in its opening while heating up the area with a heat gun. the whole is a bit tight out of the printer, i suggest drilling it with a 4mm drill after printing. You need support for the lens opening and the gap for clamping. after you remove the support sand down the inner part of the clamp so your lens wont get any scratches