Langmuir Crossfire Z axis water shield v2

thingiverse

This cover is a tight slip fit over the bottom of the Z axis on a Langmuir Crossfire plasma table with a powered Z axis. It protects the Z axis rails and IHS switch from splashing water. This cover will only work with a Machine torch. There is no clearance for a hand torch mount on this version. To install, unplug the IHS wires and slide the cover most of the way on. Feed the IHS wires through the slots and then finish pushing the cover all the way on. It will be a tight fit and you may have to push pretty hard to get it the last few millimeters. When fully installed, it should extend past the back of the lower metal plate by 4mm. I printed this from PLA+ at .28 layer height, 3 walls and 30% infill.