Land Rover Brush guard support VUB501880 with rivets

thingiverse

If you have a A-polyurethane bar brushguard on your LR3 LR4 Discovery 3/4 the little top brackets are likely broken. It seems they really structural, just there to support the top of the A-bar a little. This part was printed in PTEG and works well, mirror to get the other side. ABS would be fine. I made some plastic rivets that i printed in ABS that fit for this job, although i later found i had some ones around. Only a few supports are needed. They arent super thick (as thick as the originals) but id rather have these be the weak point rather than damage the much more expensive grill that they attach to....ran out of black petg so the yellow pla one is temporary...