Lampater 2000 - LED Floor Lamp

prusaprinters

<p>Tall floor lamp for your Living Room over 1 meter tall. So this is a fairly large print in parts (about 50-70 hours depending in the infill settings).&nbsp;</p><p>To complete this is i used the following parts:</p><ul><li><a href="https://www.amazon.co.uk/gp/product/B098PHLZ3N">https://www.amazon.co.uk/gp/product/B098PHLZ3N</a></li><li><a href="https://www.amazon.co.uk/gp/product/B08XZ6L8S8">https://www.amazon.co.uk/gp/product/B08XZ6L8S8</a></li><li><a href="https://www.amazon.co.uk/gp/product/B06XPCLN23">https://www.amazon.co.uk/gp/product/B06XPCLN23</a> (not mandatory)</li></ul><p>Create this lamp by printing the following:</p><ul><li><strong>1 x Lampater2000-Base</strong> | use a big number in the infill here since this the part we need to be heavy to keep the lamp steady. <i>Print with the top laying in the bed no supports</i></li><li><strong>1 x Lampater2000-Top</strong> | this part is the top of the lamp, still needs improvement and to be a bit tall….no need to be more than 10-15% infill. <i>Print with the top laying in the bed, brim and no supports</i></li><li><strong>4 x Lampater2000-LedStripe-Rail</strong> | this is the most crucial part which will join each other, the top two with 10% infill and the bottom two with more up to 25%. <i>Print with the holes top laying the bed, large brim and no support.</i></li></ul><p>As you can see from the photos, printed mine using Wood PLA and had a lot of stringing in the joints. That plus my poor sanding cause some joints to break but nothing super glue couldn't fix :)</p><p>&nbsp;</p>