Lamp shade for window or wall

prusaprinters

Lamp shade for window or wall, hanging angled 45 degrees. Cable to be routed from shade up to e.g. top of window, than back through the lamp shade and then back 45 degrees , see picture. The lamp shade are threaded M10 x 1 to fit cable strain relief and nipple. Add cable, cable strain relief, lamp socket and lamp bulb. Strain relief can be printed using https://www.prusaprinters.org/prints/24448-lamp-cable-strain-relief Cable nipple could be found e.g. https://www.clasohlson.com/se/Nippelmix/p/Pr323423000 Use lamp bulb E14, LED only to avoid overheat the lamp shade. The lamp shade can be painted e.g. black outside and gold inside. Print instructionsPrint the lamp shade with the base down. Use support and brim to ensure full support. I needed to add brim, otherwise a few mm closes to the base was not supported through the radius.