Lamp Monstrosity

thingiverse

This is a small desk lamp consisting of 11 bulbs connected in the middle by a D12. All of the parts, including the bulbs, are printable. It is driven by an Adafruit Feather 32u4, which has BTLE, so the lamp can receive commands from your phone. # 3D Printed Parts * base reinforcement x1 * base top x1 * base middle x1 * bulb x11 * connector x1 * base bottom cover x1 * pole x1 # Electronics * [Adafruit Feather 32u4](https://www.adafruit.com/product/3242) * [Level shifter](https://www.adafruit.com/product/1787) * [5V power supply](https://www.adafruit.com/product/276) * [Power adapter](https://www.adafruit.com/product/368) * [Momentary push button](https://www.adafruit.com/product/481) * [On/off switch](https://www.adafruit.com/product/916) * [11 neopixels](https://www.adafruit.com/product/1312) * [5.5 x 2.1mm DC power jack](https://www.amazon.com/gp/product/B08SJM2G52/ref=ppx_yo_dt_b_asin_image_o01_s00?ie=UTF8&psc=1) # Source Code https://github.com/rbedger/lamp # Instructions * print all the parts * use super glue to join the following parts together: * base middle * base top * base reinforcement * pole * connector * run power/ground/data wires up through the pole and out one of the holes in the connector * solder input and output wires to the neopixel * route output wires back into connector and out through a different hole * repeat until all connector holes have neopixels * super glue the bulbs into place * thread both buttons and power jack through the holes of "base middle" * solder everything together - be sure to use the level shifter! * program your arduino. my source code is [here](https://github.com/rbedger/lamp) * jam everything into the base and glue the "base bottom cover" into place