Lamicall T Stand Depth Extender

prusaprinters

The depth of the stand's cradle with these extenders installed is 20mm.Instructions (see pictures for details): Remove the silicone gasket on the Lamicall T Stand.While holding the gasket and looking at it from the top down, using a sharp knife or craft scissors, cut the arm pieces away from the back piece by slicing straight down where the arms meet the back piece. Reinstall the now-armless gasket. Print 2x of this model. Press-fit them onto the now bare-metal arms until they seat fully up against the silicone gasket. It will be a tight fit, by design, so don't be afraid to press hard if needed.Optional: glue on some rubber sheeting to the top and inside face of the depth extenders (not pictured). You probably don't need to bother though, as I've found the gasket covering the back face of the stand has been sufficient to keep my devices from sliding around on the stand.