Lamicall Gooseneck Tablet Holder Fix

thingiverse

Replacement part to fix the Lamicall Gooseneck Tablet Holder. Interfaces between the clamp and the shaft that remains after the short flexible portion of the neck fatigues and breaks. M4x20 or similar screws and nuts required to prevent the collar from sliding off of the shaft.Disassemble clamp by removing 4 screws and the larger bolt/nylock nut and washers.Fasten the printed collar to the swiveling piece of the clamp. The torque of this bolt determines how easily the tablet will rotate on the arm, so set to your desired spec. Remember that the mass of the tablet will make it easier to rotate, so go tighter than you might initially think.Slide collar over the remaining portion of the shaft that is connected to the table clamp. You may need to trim away the white sleeve to expose the raw metal shaft.Mark and drill the two holes for your fasteners. M4 fasteners suggested. Tighten nuts to be snug.