Lamella Curtain Holder

prusaprinters

We have had issues with our lamella curtains blowing in the wind when we kept our terrace door open, during the summer. So it was time to solve this issue.This is a simple plate with two M3 screw holes and a cylinder magnet in either end for a total of four magnets.Total print time for a set is 30 minutes on my Sovol SV06, with a layer height of 0.2.The current configuration supports my 90mm wide lamella, when pressed together they are roughly 5mm thick. The measurements in the gap is 92x7mm.Let me know if you need any other variations! Important when printing:I add a pause gcode before the 25th layer, when you can see the holes about to be covered. Then I add the magnets, ensure they are firmly in place and do not go over the top.