Lambda Half Life Lámpara

thingiverse

WARNING The pieces "Lambda3D.stl", "LambdaPlano.stl", and "Marco Lambda.stl" were rescaled in "Cura" to a 160mm X coordinate, maintaining proportionality in Y. The scaling percentage for X and Y was set to 72.9% in "Cura". You can use any desired proportions. The piece "Marco Lambda.stl" is designed for attaching white paper (an 80g sheet was used) to conceal the LEDs, diffusing their light. The piece "LambdaPlano.stl" is positioned at the back of the lamp to accommodate all cables and LEDs. It was printed with a 12% fill rate. The piece "Lambda3D.stl" is a 20mm-high lambda (Z-axis) design. Care must be taken when scaling the Y and X axes, as it may cause warping. The model has a 12% padding rate and does not require support. The rest of the pieces were printed without altering their dimensions. You can scale them as desired, but beware of reducing the size too much (warping may occur). The circuit and batteries would not fit inside, depending on the components used. Five RGB LEDs were utilized to generate uniform illumination and a orange color effect. Thermal glue was used for all attachments except for "Marco Lambda.st", where "Loctite super glue" was employed to attach the paper. Subsequently, the piece and paper were attached to "Lambda3D.stl". The FreeCad file is provided for modifications.