LaCrosse Technology Battery Charger Wall Mount V2

prusaprinters

<p>Simple wall mount for the LaCrosse Technology BC-900 and BC-700 battery chargers. It may also work with the BC-1000 as the case looks similar. However, I cannot confirm as I do not have this or related models.</p> <p>New version - V2. Slight change so it can be printed on edge with the clips on the bed. This provides a much stronger clip since the bending force will not be pulling the layers apart.</p> <h3>Print instructions</h3><h3>Category: Organization Summary</h3> <p>Simple wall mount for the LaCrosse Technology BC-900 and BC-700 battery chargers. It may also work with the BC-1000 as the case looks similar. However, I cannot confirm as I do not have this or related models.</p> <p>New version - V2. Slight change so it can be printed on edge with the clips on the bed. This provides a much stronger clip since the bending force will not be pulling the layers apart.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>FlashForge</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>FlashForge Creator Pro</p>&lt;/div&gt;<strong>Rafts:</strong></div></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p>&lt;/div&gt;<strong>Resolution:</strong></div></p> <p>.2mm</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>30%</p>&lt;/div&gt;</div></p> <p><strong>Notes:</strong></p> <p>Use PLA. Any material that gives a very slight flex will work</p> <h3> Post-Printing</h3> <p>Printed using PLA. It is a snug fit but you should be able to snap in the charger by inserting the charger in an angle one side and slighting bending or using a screw driver to assist the other side over the charger .</p></p></p></p>