LACK V1 3mm acrylic door knob and stop/latch for round 3x8mm magnets

prusaprinters

I have a ton of 3x8 magnets from making stepper visualizers. I made these in FreeCAD and it was pretty easy.  The magnets fit very well.  No need for support inside the magnet hole.  I trimmed my acrylic so these sit flush.  Because of that I had to make a taller stop/latch.  My doors also had a 3mm gap because I cut my own acrylic panels.  I cut four, then cut one in half for the doors, making it a kerf width gap.  Oh well!  If you did the same, the use the DoorStop2.This design keep the magnets from slamming together directly.  They also do not need glued.  The door handle has a small hole for helping press in the magnet.