Lack Table - PTFE Passthrough

thingiverse

This pass-through is specifically designed for use with an IKEA Lack table enclosure. By utilizing either an M6 or M10 PTFE connector, you can successfully route your PTFE tubes from your MMU (or directly to your extruder if set up that way) through the enclosure with minimal heat or moisture entering or exiting via the pass-through. The orientation of the pass-through is intended to have the connector positioned at the bottom (inside of enclosure). The nut provided works seamlessly with both M6 and M10 pass-through versions, while each pass-through is threaded for the nut and PTFE connectors, simplifying the process of getting them threaded in correctly. Minimal supports are required, but they only serve to provide additional stability for the lower portion of the center tube. Further details regarding supports can be found in Print Settings.