Lack table leg extension - 10cm (for Prusa MMU2)

thingiverse

Increases the height of an Ikea Lack table by 10cm, specifically designed to add height to the Prusa Lack enclosure. To do this, attach the new pieces between the top corner pieces and the legs of the top table. Cuts are made on the inside corners for the plexi to pass through - you'll need to extend the base plexi or cut new pieces. The sides and back should measure 440x540mm, while the front door pieces are 220x540mm each. Use the beveled edge pieces on the front corners to allow clearance for the plexi doors to open beyond 90 degrees. Attach the new pieces to the legs using #10x3/4in wood screws. You can either glue them to the top corners from the enclosure kit or use a longer (1.5in) #10 wood screw to attach both to the tabletop at once. Pre-drill holes before attaching with wood screws to prevent layer separation. Use hand tools or very low torque settings on power tools.