Lack Table Foot Supports

thingiverse

I needed a stable setup for my multi-lack table enclosure, so I made a set of wider feet to support it. The original design was unstable with four tables and prone to toppling over during minor earthquakes. To address this issue, I created two variations of feet that can be used depending on the configuration of your tables. If your tables are against walls at different angles or in a corner, you can place two front-feet in front and two back-feet in back for stability. Alternatively, you can mix an angled piece into the setup to accommodate odd wall angles. Additionally, placing vibration-dampening material in the bottom of the feet will help reduce noise from your printer.