Lack stack pack. Parts for lack enclosure with risers.

thingiverse

Lack Enclosure Risers with Wall Mounting Points Provide a 6mm Rise for the Lack Legs, Ensuring a Snug Fit and Plenty of Support. A crucial update has been made to these parts since the attached photos were taken - see updated parts section below. These risers offer a 6mm rise that fits within the dimensions of the table itself, providing a snug surrounding footing for the lack legs before screwing them into place. Unlike other risers, they provide a good grip around the legs of the Lack, giving you the option to choose between permanent or temporary anchoring. All screw holes for anchoring to the Lack legs and tabletop are countersunk, ensuring a flush finish. The parts feature tabs on the side with a hole drilled through to accommodate an M4 bolt, recessed 5mm from the edge of the table. This allows you to attach panels to these tabs without compromising the structural integrity of the riser. Inner-leg tab brackets are provided for additional mid-leg mounting points, allowing you to screw the top of the panel into place. These brackets also fit nicely along the leg of the Lack, enabling you to add more if needed. Unlike other Thingiverse risers that cut a hole through the middle to save plastic and printing time, I've chosen not to use this option. The wall printing and tool direction changes actually added considerable printing time while using more plastic, without providing any additional strength. The updated parts have addressed an issue with the original design where panels wouldn't sit easily in the corners next to the riser without cutting a 2mm wide slither of plastic out. Now, you can install a perfectly square panel without trimming. Enjoy your upgraded Lack enclosure risers!