Lack Stack Kit - Table for Kids or Figurines

thingiverse

Inspired by Lack Printer Enclosure - LKM (shown in the picture to the right), I decided to create a table kit for my kids. A place where they can paint, read, do homework and more. With the exterior honeycomb design and hidden locks, not only does it increase the strength of the print but also makes it look more attractive than ordinary plane designs. I think it will outlast IKEA tables themselves. You can also use this to display your best prints, making it a very nice companion for your Lack Enclosure! =================== Note: The parts should slide on with minimal friction and ensure that you use some type of non-oil based lubricant to avoid scratching the finish. Body lotion is a good option; it doesn't soak into the material of the table and cleans off easily too. Apply the lubricant to the parts, not the table legs. If the parts slide on too loose, wrap the table legs with 1-2 layers of tape at the location where the parts and table legs touch. Use the tapes as shims and try not to make the tape visible. Use a drill bit or a tap-screw to create a hole first before fastening the screw to prevent your parts from splitting. I highly recommend using all available screw holes to make this table rock-solid. =================== Parts needed: 2 x IKEA Lack - Side Table (http://www.ikea.com/us/en/catalog/products/20011408/) $7.99 each 1 x IKEA Lack - TV unit (http://www.ikea.com/us/en/catalog/products/90243297/) $14.99 4 x LSK-Tall 6 x LSK-Short 2 x LSK-Center_Bottom 2 x LSK-Center_Top 4 x LSK-Lock (to fasten the top table) *Optional* Additional 6 x LSK-Lock (in some cases if you decide to fasten the whole thing to the floor) =================== 0.2mm Layer height 1.2mm Shell 10-20% Infill 0% Support No Raft Lack Printer Encloser - LKM https://www.thingiverse.com/thing:1843235