Lack light

prusaprinters

<p>I wanted an inexpensive way light up the lack enclosure a little better so the Lack Light was born. &nbsp;Four straights, 3 corners, and 1 corner plug &nbsp;and a hand full of wood screws are required. The mounting surface is angled so that the led lights shine roughly 3 inches off the surface of the lack table below. I used standard led strip lighting from Amazon and routed the cable down the back leg and then under the bottom table. &nbsp;The curves aren't perfect for the strip lighting so hot glue was used to “spot weld" the strip lighting to the framing.&nbsp;</p>