Lack enclosure / external controller/display mount w/floor cable port

prusaprinters

This was to accomplish two things. 1) the big access hole in the floor helps to run the ribbon/PS wires when removing the printer for cleaning/maintenence 2) I wanted to move the controller out of the enclosure so I could access the SD card while ABS prints cool slowly, side benefit is being able to access the ambient temperature sensor on the EINSY board on the ‘support’ menu without opening the enclosureThe cable port is secured with a zip tie and a zip tie head (just run the full zip tie through the bracket and run just a head down to secure it (see pic)