Lack Enclosure Drawers - Prusa Mini Edition

prusaprinters

PRUSA MINI EDITIONIs your print enclosure "lacking" storage? Well I have the solution for you! The Lack Enclosure Drawer unlocks the incredible enhancement of storage for your enclosure in a new and exciting way.*Also works great as an addition to any workbenchFeatures:• Seamless alignment for that oh-so-clean look.• Lack Drawers also include optional slots for magnets (20x5x2mm) allowing drawers to snap into place with a nice "Click"Print instructionsINTROThese drawers can be configured in a number of ways. To simplify assembly the drawer cases are alphanumerically identifiable.• R1M and R2M cases are design only for drawers on the right side end.• In a stacked arrangement A1M and R1M are all considered top row while A2 and R2 are considered second row.HARDWARE• Screws: 3x12mm wood screw or #4 x 3/4 inch screws• M2x6 Screws and M2 nuts (Used for attaching rows of drawers together)• Drill bit that is smaller diameter than the wood screws• 20x5x2mm MagnetsINSTRUCTIONS• Use printed templates to mark the hole locations on the surface you are mounting the drawer case to.• Drill out marked locations• Make sure optional magnets are installed into drawer case • Screw drawer case in place using 3x12mm or #4 x¾ inch wood screw.• Insert magnets into drawer and slide in place. (If the magnets are opposing rather than attracting you need to reinstall them facing the opposite direction.) • If installing second row of drawers you will need to insert the M2 nuts into the hex slots on the A1M or R1M case. (Using a long M2 screw threaded into the hex to pull it in place is an easy way to do this.)• Attach A2M or R2M cases to the above hex nuts using M2x6 screwsNOTE: all drawer cases will work fine if a single row of drawers is desired.Filament: PLA (PETG or ABS for heavier duty storage)Nozzle Size: 0.4mmPrint Height: 0.2-0.35mmInfill: 10-20% Looking for the Original Lack Enclosure Drawers?Original Lack Enclosure Drawers (For MK3)