Lack Drawers

thingiverse

Once upon a time i found some IKEA-Lack Drawers on thingiverse. But there was only a picture and one drawer. Everything else was gone. So i decided to make my own. This is what i have done and it was frustrating. So this is not fully useable!! 1. I miscalculated the overall width by a few millimetres, so the small long drawer does not quite fit. 2. I planned a storage for 5 printbeds to put underneath the drawers. But the space downwards was not enough. This cost a lot of filament, time and nerves and strength. So i stopped eventually. Maybe someone else can use this to create something better. The parts were sized to fit my Printer: 21x21x25 mm (actually i think i used 20x21x24) Screwing the parts to the Table was hell as well, because there was barely any space to use a screwdriver and i needed a lot of force to screw them in. Hint: Screw in the left and right side at first. Hold everything else in place to see how it fits best.