Labyrinth

thingiverse

Create a labyrinth to keep you entertained during long journeys or dull meetings! Challenge yourself to move both marbles from one end to the other, and then try moving only one marble while keeping the other in place. The single-piece board has just enough space for the marbles to roll freely without falling out. Designed by Chris. To print this labyrinth, use ABS filament, with an infill of 10%, layer height between .20 and .25, and one extra shell. For the marbles, opt for PLA with 10% infill, a layer height of .27, and one additional shell. Before playing, run a track cleaning tool along the entire length of both sides of the track to remove any small burrs or imperfections. Next, insert a 1/4" steel bearing into the outer start point of the track - it should click into place. Finally, use the tool to smooth out any areas where the bearing might get caught for a seamless playing experience.