Labrador (Female)

thingiverse

This is a fresh spin on 3DWPs' fantastic Labrador Sculpture, polished up and stripped of any unwanted details. I created this as a gift for my mom, whose two beloved Labradors were both female - no way was that bulge going to pass off as a lady's figure. Please note, I resized it to make it approximately 230mm tall, using about 300g of filament in the process. The print took around 27 hours to complete, with support settings including zig zag with a density of 15% and a Z distance of .1. In most cases, they popped right off without any issues. If you decide to print this out, be sure to share a photo! Enjoy! Tip: After removing the supports, take a lighter to the area to bring back the vibrant colors!