L6-30 Drok kWh Power Meter

thingiverse

*Attention* this design assumes you know how to properly handle high voltage safely. I take no responsibility for anything, should it go wrong. This design was originally from SpaceGoats. https://www.thingiverse.com/thing:4604901 It did not quite fit the meter securely and I did not want to glue it. I also wanted something a bit different and wanted the outlet to be a bit more secure, so I redesigned the whole thing. The meter snaps in place and the whole box can be assembled with various hardware. This design uses the following components. - 3D printed box and lid - Drok power meter https://www.amazon.com/gp/product/B07YC1XHKQ - Cable (I had to trim one of the prongs because I actually wanted to use it in another L6-30R) https://www.amazon.com/gp/product/B07MG9C48C - Leviton L6-30R plug https://www.amazon.com/gp/product/B00002NAT9 I had some hardware laying around. I used self tapping sheet metal screws to hold the lid on the box and I used some machine screws with nuts on the back of the lid to hold the outlet in place. I am not sure how accurate the meter is, but its better than nothing. Cheers and happy printing!