L`ill Planter on Feet

cults3d

Enjoy the freedom of variants with this handy planter: Features: Choose different materials / colors for inlets, feet and bowl No special multi material printer needed Print it in Vase or native mode Scale it up easy for bigger planters Let it float on feet or set it flat on the ground. Two dish variants. Summary To drain excess water there is a sink in the bottom of the bowl. Place the drain-sprout in there to guide the drainage water. Indoor use: Print the dish with cone for planters on feet. The cone prevents dripping water from splattering in the dish. Print the flat dish for planters sitting on bottom. In this case leave the sprout. For each planter on feet, you have to print 9 inlets and three feet. Feel free to apply more feet and less inlets. The flat sitting variant needs at least 12 inlets. Assembly Snap the inlets from the top side downwards in until they fit tight. If they sit too loose or the feet snap out, you had to add a bit of glue in the slots or slightly up scale the inlets. It's generally good idea to print one test inlet before to double-check the fitting.