L bracket spacer for DDR, ITG, PIU arcade pads

prusaprinters

<p>This bracket is sized to work on all arcade dance pads that I know of that use an L-bracket sensor arrangement - that being mainline PIU, all gens of DDR (except Solo), and ITG pads. I've omitted the third screwhole, as it's largely redundant in most situations. This saves on material costs, as well as print time. I run these in my pads, and I've never had an issue with them.</p><p>This upgrade is especially recommended on DDR pads, where the screw-spacer-washer arrangement will commonly come unscrewed over time, leading to bent screws, scratched brackets, and 3 times as many parts per bracket as is necessary.</p><p>Printing in PLA is perfectly fine. A material that's more abrasion-resistant would also potentially be helpful, if your printer can use them effectively.&nbsp;</p><p>Note: during installation, please verify the screwposts make contact with the back of the pad frame on both sides, as seen in the second photo. If one side isn't making contact, the bracket may be on crooked, which could impede gameplay and induce wear.&nbsp;</p>