Kyosho Ultima Front Spindle Carriers

thingiverse

Front spindle carrier for the Kyosho Ultima series (Ultima / Ultima II / Outrage / etc.). This is pretty true to the original but based on the re-release design - with some very slight differences. The overall height is slightly taller, as the original spindle carrier actually had some slop relative to the caster block. Ream the hinge pin pivot with a 4 mm drill bit. If you have one, use a 7 mm drill bit to clean out the spindle area. You may want/need to use a smaller circular file but you do need to take care not to ream it out too much or the axle/spindle will be too loose. Carefully push it into place - it should be relatively tight. Depending on your print orientation, you may want to file the face of the carrier that faces the wheel/rim to ensure that it does not rub. This likely will work in a pinch but getting this made out of nylon or using originals is probably going to be more robust than printing with other materials.